ARPM Rubber Manufacturing Forum

Does anyone have any recommendations for OSHA compliant blow off nozzles that would keep us from having to reduce our air pressure to the 30 psi required by the standard? We use these a lot for demolding and removing flash and runners from molds. We would prefer something with a rubber or non marring tip so that we don't damage molds.

Thanks for the help!
John

We have been slowly converting to complaint nozzles that have some alternative path for the air in the case that the primary exit hole gets blocked. I believe these are complaint and allow you to keep your plant air pressure at 80+ psi.
You can contact Tim Zeigler at our facility for specific information. 216-391-2928